



1/2" Copper Union - Solder Sweat DIY Ethanol Moonshine Pot or Reflux Still part
$17.00
TypeClamps, fittings & parts
SizeSee listing
MaterialCopper
ConditionNew
ShippingFree
Sellerlionbrewingsolutions (99.7% positive)
Ships fromUS
You'll finish your purchase on eBay. Price and stock can change — eBay shows the final price. Covered by the eBay Money Back Guarantee.
About this item
A 1/2" copper union is the small fitting that makes a homemade still easy to service. Sweat it into a line on your pot or reflux still, and you can split that line later to clean it, swap a condenser or try a new setup without cutting pipe.
How do you install a solder sweat copper union?
Clean and flux the pipe ends and the union sockets, heat the joint, and let the solder draw in. Use a lead-free solder that suits your project.
- Size: 1/2" sweat. Match it to your pipe size before ordering.
- Material: copper, so it fits right in with copper lines.
- Count: the title doesn't say whether it's one piece or a set, so check the listing.
- Why it matters: a point where the line comes apart makes cleaning much easier.
New at $17.00 from an independent eBay seller and covered by the eBay Money Back Guarantee. Stills also run water, essential oils and fuel alcohol. Making spirits needs a TTB permit.
More clamps, fittings & parts

3" Tri Clamp Screen Gasket Viton w/ Stainless Screen 20 Mesh 841 μm ➔ Distilling
$17.00 + free ship

SILICONE TRI CLAMP CLOVER SCREEN GASKET 2" 20 MESH Moonshine still
$16.99 + free ship

8" Viton, Tri Clamp, Tri Clover, Sanitary, Gasket, Seal for still, etc
$16.48 + $20.00 ship

Still Spirits T500 Water Flow Controller with adpators Top Brew Supplies
$17.89

Tri-Clamp/Tri-Clover Ferrule | 3 inch (3"), Stainless Steel 304, Short Weld
$17.98

2" x 1/2" COPPER REDUCER COUPLING PIPE FITTING MOONSHINE STILL COLUMN
$17.99 + free ship

2" x 3/4" COPPER REDUCER COUPLING PIPE FITTING MOONSHINE STILL COLUMN
$17.99 + free ship

Beer Keg Gasket - 2 inch Tri Clamp -Flat one side Beer Keg Still Moonshine-3pack
$17.99 + free ship