









(4) 2" Copper Tri Clamp Ferrules Beer Keg Still Adapter Fits 2" Copper Pipe qty4
$68.00
TypeClamps, fittings & parts
SizeSee listing
MaterialCopper
ConditionNew
ShippingFree
Sellerlionbrewingsolutions (99.7% positive)
Ships fromUS
You'll finish your purchase on eBay. Price and stock can change — eBay shows the final price. Covered by the eBay Money Back Guarantee.
About this item
Four 2" copper tri clamp ferrules make a starter kit for building your own keg still parts. Solder one onto 2" copper pipe and you get a clean joint you can take apart. That means you can rearrange columns, condensers and spools to test new setups. The set is listed New at $68.00.
How do copper tri clamp ferrules fit 2 inch copper pipe?
The title says they fit 2" copper pipe. You usually solder the ferrule on, then clamp it to another 2" tri clamp part with a gasket between them.
- Check the listing for which copper pipe type the ferrules are sized for.
- Clamps and gaskets aren't mentioned in the title, so plan to buy them separately if needed.
- Use lead-free solder and flux on anything that touches vapor or distillate.
- Four ferrules make two complete clamp joints.
These work for water and fuel alcohol rigs too. Covered by the eBay Money Back Guarantee.
More clamps, fittings & parts

Push to Connect Cooling Plumbing Kit, 4" Copper & Stainless Bubble Plate Column
$67.26

Sanitary Tri Clamp 4" x 12" w/ 1 Clamp And Gasket
$73.00 + free ship

Still Dragon 1.5" Tri-Clamp Butterfly Valve (Lot of 2)
$75.00 + free ship

Push to Connect Cooling Plumbing Kit, 2" & 3" Copper Reflux Columns
$60.53

2" Stainless SS304 Tri-Clamp 180° U-Bend ➜ Distilling Moonshine Column Flute
$60.00

Tri-Clamp Distillation Lid | 2" T.C. | BrewZilla | DigiBoil | 35L - fits many
$60.00 + free ship

3" Stainless Steel Surge Breaker for Moonshine Still Column
$59.40

Still Spirits T500 Lid for Boiler 48 mm Hole - Fits Digiboil, Robobrew, Brewzill
$79.00 + free ship